REELEX Equipment Installation and Commissioning

Who is responsible for what?

Customer Responsibilities

Shipping

Most REELEX equipment is sold ex-works unless otherwise negotiated. When your equipment is completed, we will contact you regarding making shipping arrangements to pick up the equipment.

Setting Equipment in Place

Because we do not know your plant or the other equipment in the line, customers are responsible for setting the equipment in place, aligning other components in the line and bringing air and power to the machines. Once completed, we will send technician/s to commission the equipment.

  • Prior to equipment arrival, please have the air and power supplies available as described in the Equipment section of the machine proposal (requirements are also located on the ID plates).
  • When the equipment arrives, unpack and place the machine on the floor according to the line layout drawing. Please have all additional components (printer, sparker, etc.) ready for installation when setting up the REELEX line.
  • REELEX supplies the complete line pre-wired with flexible conduit, please connect equipment using the conduits provided.
  • Make sure all bare metal components have had protective coatings removed.
Go to Line Layout Drawings

DO NOT TURN ON POWER

Do not turn on power to any equipment until REELEX personnel arrive for commissioning. Doing so may void the warranty!

Interfacing with Your Equipment

It is the responsibility of the Customer to provide for any necessary design, engineering, setup, test and debug of the interface between REELEX equipment and Buyer’s equipment unless such interface is specifically described and included as part of the equipment proposal.

REELEX technical staff are available to assist in integrating Customer’s equipment with REELEX machines.

Make Sure Product and Personnel are Available

To make sure the equipment performs up to par, make sure there is product available to run when REELEX personnel arrive. Also make sure your personnel are available for training.

REELEX Responsibilities

REELEX Technician Labor

Once equipment is installed and in place, REELEX technicians will arrive and commission the equipment. Travel expenses are additional and are billed as a flat daily rate. Up to 5 days (10 for automated equipment) of labor are provided free of charge. A typical commissioning take 3 to 5 days.

Integrating other Components with REELEX Equipment

We will work with you to integrate printers, testers and other equipment to interface with the REELEX machine. However, it is your responsibility to set up the equipment and install in the appropriate places on the line. Recommended locations are noted on the line layouts.

Make Sure Product and Personnel are Available

To make sure the equipment performs up to par, make sure there is product available to run when REELEX personnel arrive. Also make sure your personnel are available for training.

Line Layout Drawings

S320 Line Layouts

M340 Line Layouts

Questions? In need of service? Contact us!

REELEX Sales

  • Quotes for equipment

  • Samples of your product in REELEX

  • Global sales representation

  • General inquiries and questions

REELEX Support

  • Technical questions

  • Support for current machine issues

  • REELEX machine manuals

  • Schedule service or contact a technician